Makita 3612C Instruction Manual page 8

Operation
CAUTION :
0
Before operation, always make sure that the tool body automatically rises to the upper
limit and the bit does not protrude from the tool base when the lock lever is loosened.
D:+ msi,-.l '
I
ving
0
Before operation, always make sure that
the chip deflector is installed properly.
Chip
0
Set the tool base on the workpiece to be cut without the bit making any contact. Then
turn the tool on and wait until the bit attains full speed. Lower the tool body and
move the tool forward over the workpiece surface, keeping the tool base flush and
advancing smoothly until the cutting is complete.
*When doing edge cutting, the workpiece surface should be on the left side of the bit in
the feed direction. (see the figure below).
c3
Bit revolving
direction
Feed direction
Bit revolving direction
(View from the top of the tool)
I
Bit revolving direction
/ / / / / / / / I / / / /
Correct bit feed direction
I
NOTE
:
0
Moving the tool forward too fast may cause a poor quality of cut or damage to the bit
or motor. Moving the tool forward too slowly may burn and mar the cut. The proper
feed rate will depend on the bit size, the kind of workpiece and depth of cut. Before
beginning the cut on the actual workpiece,
it
i s advisable to make a sample cut on a
piece of scrap lumber. This will show exactly how the cut will look as well as enable you
to check dimensions.
*When using the straight guide or the trimmer guide, be sure to install it on the right side
in the feed direction. This will help to keep it flush with the side of the workpiece.
8