Display Switch-Off; Program Info; Memory; Water Intake - Miele WWF 060 Operating And Installation Instructions

Display switch-off

The display and the sensor button
lighting is switched off to save energy.
The Start/Stop sensor button flashes
slowly.
Options
– On
Lighting switches off after 10 min-
utes.
–
On (not crnt prog)
Lighting remains switched on
throughout the program. The lighting
switches off 10 minutes after the pro-
gram has ended.
– Off
The lighting remains switched on.

Program info

You can select the information that will
be displayed temporarily once a pro-
gram has been selected in the display.
Options
– Program name (default setting)
The program name is shown in the
display for several seconds.
– Prog. & Max load
The program name and the maximum
load is shown in the display for sev-
eral seconds.
– Off
Directly after the program has been
selected, the standard display is
shown with temperature, spin speed,
and program duration.
(default setting)

Memory

The washing machine will save the
last settings (temperature, spin speed,
and some of the extra options) se-
lected for a wash program after the
program has started.
When the program is chosen again, the
saved settings will appear in the dis-
play.
The memory function is switched off in
the default setting.

Water intake

You can program 3 options for the wa-
ter inlet. The water inlet is controlled
by the two inlet hoses.
Options
– Cold water
The washing machine will be oper-
ated with cold water only.
– Hot water  (default setting)
Hot water is used in the main wash to
save energy.
You can heat up your water with
cheaper, primary energy sources,
e.g., gas, solar power, oil. The tem-
perature must be below 140°F (60°C.)

For technical reasons, the wash-
ing machine must always be con-
nected to cold water.
Settings
79