Final Spin Speed In The Wash Program; Rinse-Spin; Omitting The Final Spin (Rinse Hold); Deselecting The Rinse-Spin And Final Spin - Miele WWF 060 Operating And Installation Instructions

Spin cycle
Final spin speed in the wash
program
When a program is selected, the opti-
mum spin speed for the wash program
is always shown in the display.
A faster spin speed can be selected for
certain wash programs.
The highest selectable spin speed is in-
dicated in the table.

Rinse-spin

There is a spin cycle after the main
wash and between the rinse cycles. A
reduction in the final spin speed will
also reduce the interim spin speed as
appropriate.

Omitting the final spin (Rinse hold)

If Rinse hold is selected, the laundry re-
mains in the water following the final
rinse cycle. This helps prevent creasing
if the laundry is not going to be re-
moved from the drum immediately after
the end of the program.
 Set the spin speed
To start the final spin:
The washing machine will display the
maximum spin speed possible. You can
reduce the spin speed.
 Touch the Start/Stop sensor button.
34
().

Ending the wash program
Use if you want to remove the laundry
when it is dripping wet and without
spinning.
 Reduce the spin speed to
 Touch the Start/Stop sensor button.
The water will be pumped away.
Deselecting the rinse-spin and final
spin
 Before the start of the wash program,
reduce the spin speed to
 Touch the Start/Stop sensor button.
After the last rinse cycle, the water will
be pumped away and the anti-crease
phase will switch on.
An additional rinse cycle is carried out
with this setting for certain wash pro-
grams.
(0 rpm).

(0 rpm).
