Honeywell Lyric User Reference Manual page 66

Video Doorbell Installation
1. Install the Video Doorbell according to its instructions.
2. Connect the Video Doorbell to your Wi-Fi® network. [If it is already connected, skip to step 3.]
a. Put the doorbell into hotspot mode by pressing and holding the doorbell button until it
blinks alternating red and green.
b. Start the Total Connect® 2.0 mobile app and select the Doorbell (Skybell) menu. Press
SETUP SKYBELL, then press NEXT.
c. Select the Video Doorbell from the displayed list of devices to connect the device to the
Video Doorbell hotspot and press NEXT.
d. Select your Wi-Fi router from the displayed list of devices to connect the Video Doorbell
to your Wi-Fi network. Press NEXT. Enter the router's password if required, then press
NEXT.
e. A popup message appears: "Your SkyBell front door has been added to Total Connect."
Press OK. The Video Doorbell is now ready to be configured for use with the Lyric™
Controller.
NOTE: The Wi-Fi sync process may require more than one attempt to connect. If needed,
use the Try Again button to reattempt.
3. Configure the Video Doorbell for use with the Lyric Controller.
a. Using the smart device browser (or PC with IE 10.0 or higher), go to:
https://hwinstall.myskybell.com/
b. Enter access code: honeywelllyriccontroller
c. Enter the Video Doorbell serial number: __________________________
(the serial number is located on the label on the back of the doorbell)
d. Select Configure.
The screen displays "Success! The SkyBell has successfully been updated with the Lyric
Panel configuration."
e. Exit the website. The doorbell is now ready to be added to the Lyric Controller.
4. Add the Video Doorbell to the Lyric Controller.
a. From the Lyric Controller touchscreen, select the SkyBell Setup option:
Home > Security > Tools > enter Master User Code >
b. The Controller displays, "To enroll a Doorbell, press a button on that Doorbell." Go to the
doorbell and press its button.
c. Press "Please select a description for doorbell" to assign the desired descriptor and to
select the desired chime sound played at the controller when the doorbell is pressed.
Press Save.
DESCRIPTOR NOTE: Select the desired descriptor from the built-in Lyric descriptors. The
Video Doorbell cannot use Custom descriptors.
d. The door bell name and serial number appear on the Lyric screen. The Video Doorbell is
now ready to be used.
NOTE: If the message "Please select a description for doorbell" does not appear, repeat
steps 3 and 4.
(go to 2nd page) > SkyBell Setup
66