Preparations And Connecting Peripheral Devices - NEC DX2000 User Manual

Chapter 2 Installation and connection
2.

Preparations and connecting peripheral devices

The following items must be prepared before turning on the server.
Connectors that allow a variety of peripheral devices to be connected are provided at the front and rear of the
server. Images on the following pages show the peripheral devices that can be connected in their standard state
and their respective connector positions.
Description about ipmitool is given on the next and the subsequent pages. However, it is described as a use
example, and NEC does not assure the support of ipmitool. For details of ipmitool, contact your sales
representative.
54
WARNING
Be sure to observe the following precautions to use the server safety. Failure to
observe the precautions may cause death or serious injury. For details, refer to
Safety precautions in Precautions for Use.
Do not hold the power plug with wet hands
●
● Do not connect the ground wire to a gas pipe
CAUTION
Be sure to observe the following precautions to use the server safely. Failure to
observe the precautions may cause burns, injury, and property damage. For
details, refer to Safety precautions in Precautions for Use.
Use only the specified outlet to insert.
●
Do not connect the power cord to an outlet that has an illegal number of
●
connections.
•
Insert the power plug into the outlet as far as it goes.
• Use only the specified power cord
•
Do not connect or disconnect the interface cable with the power plugged in
the outlet.
• Use only the specified interface cable
Scalable Modular Server DX2000 User's Guide
2. Preparations and connecting peripheral devices