TM
Table 4
Troubleshooting
Problem
Solution
Check orientation of batteries�
NaviTrack Line Transmitter will not turn
Check that batteries are charged�
ON
Check that the battery contacts are clean and unbent�
Increase power output
Check that the transmitter is in the correct mode� See the descriptions for
Direct Connect Mode, Inductive Clamp Mode, and Inductive Mode�
Check that the receiver and the NaviTrack Line Transmitter are set to the same
Receiver will not pick up the NaviTrack
frequency (for example, some receivers will use 93,622�9 Hz or 93,696 Hz
Line Transmitter's signal
instead of 93 kHz)�
Ensure the leads to the line and to the ground are attached securely�
Too much resistance may be impeding current flow� Improve ground conditions
by deepening the stake, moistening the ground, or relocating the stake� Improve
the circuit by relocating the transmitter line�
14 – English