Table of Contents
Advertisement
SeekTech
ST-33Q
®
Table 6
Troubleshooting
Problem
Solution
Check orientation of batteries
ST‑33Q will not turn ON
Check that batteries are charged
Check that the battery contacts are clean and unbent
Check that the circuit is complete
Check that the transmitter is in the correct mode� See the descriptions for
Direct Connect Mode, Inductive Mode, and Inductive Clamp Mode�
Check that the receiver and the ST‑33Q are set to the same frequency (for
example, some receivers will use 93,622�9 Hz or 93,696 Hz instead of 93
Receiver will not pick up the line
kHz)� Create custom frequencies to exactly match the receiver�
transmitter's signal
Ensure the proper functions are activated on the receiver�
Press up the Up Arrow Key
to increase the power output
Ensure adequate grounding and improve if possible
Power the ST‑33Q OFF and ON
LCD screen completely dark or light
Check and adjust LCD brightness from the Tools Menu
when the ST‑33Q is ON
If exposed to excessive heat or sunlight, allow the ST‑33Q to cool
Remove and replace or recharge batteries�
ST‑33Q appears stuck in one mode
and will not reset
Apply external power source
20 - English
Advertisement
Table of Contents
