Show Running-Config Interface - Cisco nexus 3000 series Command Reference Manual

show running-config interface

S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
show running-config interface
To display the running configuration information for interfaces, use the show running-config interface
command.
Syntax Description all
ethernet slot/port
loopback if_number
mgmt mgmt_intf
port-channel number
Command Default
Displays only the configured information.
Command Modes EXEC mode
Command History Release
5.0(3)U1(1)
Examples
This example shows how to display the running configuration for a specified Ethernet interface on a
switch that runs Cisco NX-OS Release 5.0(3)U2(1):
switch# show running-config interface ethernet 1/5
!Command: show running-config interface Ethernet1/5
!Time: Fri Aug 26 04:12:01 2011
version 5.0(3)U2(1)
interface Ethernet1/5
speed auto
switch#
Related Commands Command
copy running-config
startup-config
Cisco Nexus 3000 Series NX-OS System Management Command Reference
-SM-270
show running-config interface [all | ethernet slot/port | loopback if_number | mgmt mgmt_intf |
port-channel po_number]
(Optional) Displays all the default and configured information.
Specifies the Ethernet interface and the slot number and port number. The
slot number is from 1 to 255, and the port number is from 1 to 128.
Specifies the loopback interface. The loopback interface number is from 0
to 1023.
Specifies the management interface. The interface number is 0.
Specifies the EtherChannel interface and EtherChannel number. The range
is from 1 to 4096.
Modification
This command was introduced.
Description
Copies the running configuration information to the startup configuration
file.
Chapter System Management Commands
OL-29557-04