Fujitsu M10 Product Notes page 61

Table 3-5 Problems that might occur with XCP 2240 and workarounds (continued)
SPARC M10-
RTI No. 1 4 4S
RTIF2- x
131213-002
RTIF2- x
131213-003
RTIF2- x x x
131213-010
Description
While in the process of adding or
removing a system board (PSB) using the
addboard(8) or deleteboard(8) command
of the DR feature, if another physical
partition is rebooted due to hardware
failure or the poweroff(8)/poweron(8)/
reset(8) command is executed on it, the
executed addboard(8) or deleteboard(8)
command may detect timeout and
terminate abnormally.
While executing the poweroff(8)/
poweron(8)/reset(8) command on a
physical partition, if the addboard(8) or
the deleteboard(8) command of the DR
feature is executed on another physical
partition to add or remove a system
board (PSB), the addboard(8) or
deleteboard(8) command may detect
timeout and terminate abnormally.
When the firmware of the PCI Expansion
Unit is updated with the "ioxadm –c
update" command, process down may
occur at the XSCF firmware.
Workaround
Do not execute the poweroff(8)/poweron
(8)/reset(8) command while the
addboard(8) or deleteboard(8) command
is being executed.
There is no effective workaround if any
hardware failure occurs while executing
DR.
[How to restore]
Check the status of the system board
(PSB) using the showboards(8) command.
Execute the addboard(8) or deleteboard
(8) command after that.
Do not execute the addboard(8) or
deleteboard(8) command while the
poweroff(8)/poweron(8)/reset(8)
command is being executed elsewhere.
There is no effective workaround if DR is
executed while also executing power
supply operations on another physical
partition.
[How to restore]
Execute the following:
1. Execute the showboards(8) command.
2. Check the status of /Pwr/Conn/Conf/
Test of the system board (PSB) to
confirm the end of power operations.
- End of power-on/reset:
The status of Pwr/Conn/Conf/Test is
"y y y passed" respectively.
- End of power-off:
The status of Pwr/Conn/Conf is "n n
n" respectively
3. Re-execute the addboard(8) or the
deleteboard(8) command.
There is not effective workaround.
Re-execute the "ioxadm –c update"
command to update the PCI Expansion
Unit firmware again.
Chapter 3 Information on Software 47