GE L30 Instruction Manual page 309

CHAPTER 5: SETTINGS
A description of the operation of the breaker control and status monitoring features is provided in chapter 4. Information to
program the settings is covered here. These features are provided for two or more breakers; a user can use only those
portions of the design relevant to a single breaker, which must be breaker 1.
The number of breaker control elements depends on the number of CT/VT modules specified with the L30. The following
settings are available for each breaker control element.
— This setting enables and disables the operation of the breaker control feature.
BREAKER 1 FUNCTION
BREAKER1 PUSH BUTTON CONTROL
— Assign a user-defined name (up to six characters) to the breaker. This name is used in flash messages
BREAKER 1 NAME
related to breaker 1.
— Selects "3-Pole" mode, where all breaker poles are operated simultaneously, or "1-Pole" mode where all
BREAKER 1 MODE
breaker poles are operated either independently or simultaneously.
— Selects an operand that creates a programmable signal to operate an output relay to open breaker 1.
BREAKER 1 OPEN
L30 LINE CURRENT DIFFERENTIAL SYSTEM – INSTRUCTION MANUAL
BREAKER 1 NAME:

Bkr 1
BREAKER 1 MODE:

3-Pole
BREAKER 1 OPEN:

Off
BREAKER 1 BLK OPEN:

Off
BREAKER 1 CLOSE:

Off
BREAKER 1 BLK CLOSE:

Off
BREAKER1 ΦA/3P CLSD:

Off
BREAKER1 ΦA/3P OPND:

Off
BREAKER 1 ΦB CLOSED:

Off
BREAKER 1 ΦB OPENED:

Off
BREAKER 1 ΦC CLOSED:

Off
BREAKER 1 ΦC OPENED:

Off
BREAKER 1 TOPERATE:

70 ms
BREAKER 1 EXT ALARM:

Off
BREAKER 1 ALARM

DELAY: 0.000 s
MANUAL CLOSE RECAL1

TIME: 0.000 s
BREAKER 1 OUT OF SV:

Off
BREAKER 1 EVENTS:

Disabled
— Set to "Enable" to allow faceplate pushbutton operations.
Range: up to six alphanumeric characters
Range: 3-Pole, 1-Pole
Range: FlexLogic operand
Range: FlexLogic operand
Range: FlexLogic operand
Range: FlexLogic operand
Range: FlexLogic operand
Range: FlexLogic operand
Range: FlexLogic operand
Range: FlexLogic operand
Range: FlexLogic operand
Range: FlexLogic operand
Range: 0 to 65535 s in steps of 1
Range: FlexLogic operand
Range: 0.000 to 65.535 s in steps of 0.001
Range: 0.000 to 65.535 s in steps of 0.001
Range: FlexLogic operand
Range: Disabled, Enabled
SYSTEM SETUP
5
5-131