Makita DVC864L Instruction Manual page 11

Install the batteries to the cleaner.
1.
Set the stand-by switch to "AUTO".
2.
Hold down the wireless activation button for about
3.
6 seconds until the wireless activation lamp blinks in red
(about twice per one second).
When the wireless activation lamp starts blinking
4.
in red, release your finger from the wireless activation
button. Thereafter, hold down the wireless activation
button again for about 6 seconds.
Description of the wireless activation lamp status
► 1. Wireless activation button 2. Wireless activation
lamp
The wireless activation lamp shows the status of the wireless activation function. Refer to the below table for the
meaning of the lamp status.
Status
Color
Blue
Standby
Green
Tool
registration
Cancelling/ Red
erasing
(slow: 2 times/sec.)
tool
registration
Others
Red
Off
1
Wireless activation lamp
Duration
On Blinking
Cleaner: con-
Tool: 2 hours
When the tool is
running.
20 seconds
2 seconds
20 seconds
When the
wireless acti-
(fast: 5 times/sec.)
vation button is
pressed down.
2 seconds
3 seconds
-
When the wireless activation lamp starts blinking
5.
fast (about 5 times per one second) in red, release your
finger from the wireless activation button. When the
wireless activation lamp lights up in red and later lights
off, all tool registrations are erased.
NOTE: If the wireless activation lamp does not blink
in red, press the wireless activation button briefly and
try again.
2
Waiting for the tool registration or the wireless activation function
tinuing
The lamp on the cleaner blinks when the stand-by switch is set in
AUTO. The lamp on the tool blinks when the wireless activation
button is pushed. The lamp on the tool will automatically turn off
when no operation is performed for 2 hours.
The wireless activation of the cleaner is available and the tool is
Ready for the tool registration. Searching the tool to be registered.
The tool registration has been finished. The wireless activation
Ready for the cancellation of the tool registration. Searching the
The tool registration has been cancelled/erased. The wireless
activation lamp will start blinking in blue.
The power is supplied to the wireless unit and the wireless activa-
The stand-by switch is not set to "AUTO".
-
11 ENGLISH
Description
is available.
running.
lamp will start blinking in blue.
tool to be cancelled.
Ready to erase all tool registrations.
tion function is starting up.