Channel Auto-Inhibits - Honeywell touchpoint pro Operating Manual

NORMAL OPERATION

6.11.2 Channel Auto-Inhibits

Auto-inhibits may occur when a mV input channel has been configured but not yet calibrated, when a transmitter is signalling
Inhibit, or when an Inhibit delay time is running. Please refer to Ch.10 Potential Issues for further information.
Auto-inhibits cannot be cleared manually.
CAUTION
It is possible to have more than one inhibit condition active on a channel, and you have to resolve all inhibit
conditions before the inhibit can be cleared.
Figure 42. Inputs Screen with menu options
Touchpoint Pro
Pt. No. 2400M2566_1_EN 48 Operating Manual