Table of Contents
Advertisement
FlexPower ONVIF Wire-Free IP Camera and Base Station User Manual
Add a Camera by Synchronizing It With the Base Station
You can add up to four cameras to a single base station. You add a camera by synchronizing it with the
base station, that is, you cannot add a camera through the local browser interface of the base station.
Before you add a camera, make sure that the rechargeable battery is installed in the camera and the camera
is powered on.
To add a camera:
1.
Place the camera 2 to 4 feet (60 to 120 cm) from the base station.
After you add the camera to the base station, you can place the camera at its permanent position.
2.
Press the SYNC button on the front panel of the base station for about two seconds and release the
button.
The base station camera LED blinks green, indicating that the base station is attempting to pair with a
camera.
3.
Press the SYNC button on top of the camera for about two seconds and release the button.
The camera LED blinks blue, indicating that the camera is attempting to pair with the base station. When
the camera is synchronized with the base station, the camera LED on the camera blinks blue rapidly
and the camera LED on the base station lights solid green to confirm the synchronization.
If the synchronization is not successful, the camera LED blinks amber. In such a situation, repeat Step
2 and Step 3.
4.
To verify that the camera is synchronized with the base station, do the following:
a.
Open a web browser from a computer or mobile device that is connected to the same LAN as the
base station.
If you are unable to connect to the same LAN using WiFi, use an Ethernet cable to connect a
computer to the same router or switch as the base station.
b.
Enter the domain name or IP address of the base station.
Manage Base Station Settings
24
Advertisement
Table of Contents
