Authentication By Contactless Card - Canon Oce PlotWave 300 Administration Manual

Authentication by Contactless card

Authentication by Contactless card
Requirements
Introduction
To use the authentication by contactless card, the contactless card and the contactless card
reader must comply with the following requirements:
Requirements for the contactless card
Contactless card configuration
The contactless card embeds all information (user/password/domain/...) which will be checked
with Active Directory.
Compatible contacless cards
• Felica (Felica, Felica Lite, Felica Lite-S)
• Mifare (Mifare Classic 1K, Mifare Classic 4K,Mifare Plus, Mifare DESfire EV1, Mifare Ultralight,
Mifare Ultralight C)
Compatible contactless card readers
• Sony RC-S380(/S)
• Advanced Card Systems (ACS) ACR1252U
• Advanced Card Systems (ACS) ACR122U (no support of Felica Lite cards)
• Readers compatible with the CCID and PC/SC standards may work with restrictions :
• disabling beep not supported
• configuration of card types in Océ Express WebTools is not supported, so other cards than
Felica or Mifare may work. (The 'Type of contactless card' setting in 'Océ Express WebTools
- Security - Configuration - User access configuration' has no influence in this case)
Additional information
- Contact your Canon representative in case you want to use a contactless card or a contactless
card reader which is not recorded in the above lists.
- Plug the contactless card reader into the USB port (contact your local Canon representative).
Configure the Contactless card authentication
Introduction
Perform the following steps to activate the user authentication and configure the contactless card
authentication.
Before you begin
The contactless card and the contactless card reader are compliant with the requirements.
Activate the contactless card authentication
1. In a web browser, enter the URL or IP address of the printer to open Océ Express WebTools
2. Open the 'Security' - 'Configuration' page.
Log in as a system administrator if requested.
3. In the 'User access mode' section, select 'Contactless card' as the 'User authentication':
182 Chapter 4 - Security on Océ PlotWave 345/365 and Océ PlotWave 450/550