Custom Labeling Of Leds - GE B30 Instruction Manual

4 HUMAN INTERFACES
• GROUP 1...6: The illuminated GROUP is the active settings group.
Firmware revisions 2.9x and earlier support eight user setting groups; revisions 3.0x and higher support six setting
groups. For convenience of users using earlier firmware revisions, the relay panel shows eight setting groups.
NOTE
Please note that the LEDs, despite their default labels, are fully user-programmable.
The relay is shipped with the default label for the LED panel 2. The LEDs, however, are not pre-programmed. To match the
pre-printed label, the LED settings must be entered as shown in the User-programmable LEDs section of chapter 5. The
LEDs are fully user-programmable. The default labels can be replaced by user-printed labels for both panels as explained
in the following section.
a) ENHANCED FACEPLATE
The following procedure requires the pre-requisites listed below.
• EnerVista UR Setup software is installed and operational.
• The B30 settings have been saved to a settings file.
• The B30 front panel label cutout sheet (GE Multilin part number 1006-0047) has been downloaded from
http://www.gegridsolutions.com/products/support/ur/URLEDenhanced.doc
• Small-bladed knife.
This procedure describes how to create custom LED labels for the enhanced front panel display.
1. Start the EnerVista UR Setup software.
GE Multilin
SETTINGS IN USE
Figure 4–21: LED PANEL 2 (DEFAULT LABELS)
B30 Bus Differential System
4.3 FACEPLATE INTERFACE
842783A1.CDR

4.3.3 CUSTOM LABELING OF LEDS

and printed.
4
4-17