Optical Amplifier Module Models - Cisco GS7000 Installation And Configuration Manual

Chapter 3 Setup and Operation
Important: For mounting in a hub, the pin adaptor must be installed with the blue
side facing out as shown.
Refer to Optical Amplifier and Optical Switch Module Pin Adaptor (on page 100)
for pin adaptor installation instructions.

Optical Amplifier Module Models

The following table describes the available EDFA models for the Model GS7000
Optical Hub.
Model
GS-EDFA-BCST-
17-SA
GS-EDFA-BCST-
20-SA
GS-EDFA-BCST-
22-SA
GS-EDFA-GF-
17L
GS-EDFA-GF-
17H
GS-EDFA-GF-
21L
GS-EDFA-GF-
21H
54
Description
17 dBm broadcast
EDFA
20 dBm broadcast
EDFA
22 dBm broadcast
EDFA
17 dBm gain flattened
low gain EDFA
17 dBm gain flattened
high gain EDFA
21 dBm gain flattened
low gain EDFA
21 dBm gain flattened
high gain EDFA
Operating Mode
Default: Constant power at 17 dBm
Optional: Constant gain at 12 dB ± 2 dB
Default: Constant power at 20 dBm
Optional: Constant gain at 15 dB ± 2 dB
Default: Constant power at 22 dBm
Optional: Constant gain at 17 dB ± 2 dB
Default: Constant gain at 7 dB (± 2 dB range)
Optional: Constant power at 17 dBm
Default: Constant gain at 12 dB (± 2 dB range)
Optional: Constant power at 17 dBm
Default: Constant gain at 11 dB (± 2 dB range)
Optional: Constant power at 21 dBm
Default: Constant gain at 16 dB (± 2 dB range)
Optional: Constant power at 21 dBm
OL-29936-01