Buffalo TeraStation 1000 User Manual page 77

These devices are supported:
• USB mass storage devices
• Card readers (except for card readers that can recognize two or more memory cards)
• Digital cameras and other PTP devices
1
In Settings, click Backup.
2
Move the Direct Copy switch to the
3
Connect the USB device. When it mounts (about 10 seconds), the function LED will light up.
Note: Unsupported devices will not cause the function LED to light.
4
You now have 60 seconds to press the function button. For TS1400D and TS1400R models, press and hold it
down until the unit beeps. If you do, the function LED will flash as all the files on the USB device are copied to
the Direct Copy folder ("share" is configured as a default) of the TeraStation.
Notes:
• While the function LED is flashing, press the function button once to cancel Direct Copy.
• For digital cameras that are not in the USB mass storage class, all files in the digital camera are copied.
• To change the Direct Copy target folder, navigate to Backup - Direct Copy - Edit, select a new folder, and click OK.
5
When the copy operation is finished, the access LED of the USB device will stop flashing and the function
LED on the TeraStation will be extinguished. Dismount the USB device from the TeraStation referring to the
"Dismounting Drives" section in chapter 4. Direct Copy is now finished.
position to enable Direct Copy.
76