Makita 4101RH Instruction Manual page 6

1. Wing bolt
2. End of blade case
3. Red line
2
1. Base
2. Top guide
1
1. Switch trigger
2. Lock-off button
ASSEMBLY
6
Loosen the wing bolt on the depth guide and move the base so that the end of
003516
the blade case is above the red line on the depth guide. Then tighten the wing
1
bolt to secure the base.
NOTE:
• If the end of the blade case is under the red line on the depth guide, the
outer flange may hit the workpiece when you perform the bevel cut.
2
3
Sighting
003520
1
For straight cuts, align the "A" position on the front of the base with your cut-
ting line. For 45° bevel cuts, align the "B" position with it.
A
B
Switch action
003523
CAUTION:
• Before plugging in the tool, always check to see that the switch trigger
2
actuates properly and returns to the "OFF" position when released.
To prevent the switch trigger from being accidentally pulled, a lock-off button is
provided.
To start the tool, push in the lock-off button and pull the switch trigger. Release
the switch trigger to stop.
CAUTION:
• Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.