Specifications - Makita 4101RH Instruction Manual

SPECIFICATIONS

Wheel diameter
Max. cutting capacities
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the tool. Be
sure that you understand their meaning before use.
...................Read instruction manual.
..................The tool should be used on horizon-
tal surfaces.
..................Do not use the tool upside down.
...............The tool should be used with the
PRCD (Portable Residual Current
Device).
..................Do not use the abrasive cut-off
wheel.
.................After use, brush off accumulation of
dust on the base.
.................Do not use the saw blade.
..................Only for EU countries
Do not dispose of electric equipment
together
material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life
must be collected separately and
returned
compatible recycling facility.
2
Model
90°
45°
-1
)
Overall length
Net weight
Safety class
with household
equipment
to an environmentally
END104-2
Intended use
The tool is intended for cutting in brick, concrete and
stone with the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. This
tool should be grounded while in use to protect the oper-
ator from electric shock. Use only three-wire extension
cords which have three-prong grounding-type plugs and
three-pole receptacles which accept the tool's plug.
For European countries only
Noise and Vibration
The typical A-weighted noise levels are
sound pressure level: 99 dB (A)
sound power level: 110 dB (A)
Uncertainty: 3 dB
– Wear ear protection. –
The typical weighted root mean square acceleration
value is 4 m/s
These values have been obtained according to EN60745.
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product
is in compliance with the following standards of stand-
ardized documents, EN60745, EN55014, EN61000 in
accordance with Council Directives, 73/23/EEC, 89/336/
EEC, 98/37/EC.
waste
and its
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
Responsible manufacturer:
Makita Corporation Anjo Aichi Japan
4101RH
125 mm
41.5 mm
26 mm
12,000
236 mm
3.0 kg
Class I
2
.
Yasuhiko Kanzaki CE 2005
Director