Pioneer PDP-501MX Technical Manual page 52

THIS ITEM IS NOT AVAILABLE. PLEASE CONTACT PIONEER FOR INFORMATION
2. After mounting the mounting hardware to the wall with the screws, fully extend the left and right vertical frames
as shown and tighten the left and right screws (c).
3 Mounting the plasma display
1. Two persons should firmly hold the left and right sides of the plasma display, as shown. Insert four monitor-
fastening bolts into appropriate openings in the wall-suspension hardware. Insert the two lower bolts before the
upper two.
2. After performing the above step, adjust the installation angle, as discussed on the next page.
52 THIS ITEM IS NOT AVAILABLE. PLEASE CONTACT PIONEER FOR INFORMATION
c
Display
Wall side
Insert the monitor-
fastening bolt into
opening in the
wall-suspension
hardware and
lower it into the
cutout.
Tighten the screw from above
to keep the bolt from working
loose.
Tighten the nut.