Pioneer PDP-501MX Technical Manual page 51

THIS ITEM IS NOT AVAILABLE. PLEASE CONTACT PIONEER FOR INFORMATION
3) Mounting monitor-fastening bolts to the plasma display
1 Mount the monitor-fastening bolts to the four rear corners of the plasma display.
1162
104 104
590
590
24-M8 (with 16ø Hole rivet)
2 Mounting the assembled mounting hardware to the wall
1. Firmly fasten the mounting hardware to the wall at a minimum of four points b, using appropriate screws or bolts.
Make sure that the screws and bolts are appropriate for the wall's strength and composition.
CAUTION
Before mounting to the wall, check that the fittings have adequate strength.
THIS ITEM IS NOT AVAILABLE. PLEASE CONTACT PIONEER FOR INFORMATION
104 104
b
b
Monitor-
fastening bolt
Monitor-
fastening bolt
The nuts of the monitor-
fastening bolts should be
tightened so that their
surface is level with the
screw.
b
b
Monitor-
fastening bolt
Monitor-
fastening bolt
51