Power On Start - Pioneer DVD-V5000 Operating Instructions Manual

09
Advanced Setup Menu
DISC: All content on the disc plays back
• SERIAL PORT
Set the RS-232C interface to use with a 15-pin
connector or a 9-pin connector. Only a single
type of connector may be used at a time.
Use (cursor left/right) buttons to
alternate between 15 Pin and 9 pin (Default
setting is 15 Pin).
15 Pin: When connecting to a PC
9 Pin: When connecting to a PC
• BAUD RATE
Set the Baud rate for the RS-232C
interface.
Use (cursor left/right) buttons to
alternate between 19200 bps and 9600 bps
(Default setting is 19200 bps).
• EXTEND TERMINAL
Use the Extend Terminal to select a switch-
key setting.
Use (cursor left/right) buttons to
alternate between Standard and User
(Default setting is Standard).
Standard: The unit responds according to
User: The user selects how the external
• SYNC OUT (During SQ)
Use SYNC OUT to determine if a video signal
is sent when the player is not playing video.
Use (cursor left/right) buttons to
alternate between ON and OFF (Default
setting is OFF).
OFF: Video is output constantly; the
ON: Video is not output except
42
again (repeats).
using a Pioneer or other
brand 15-pin to 9-pin cable.
using a commercial 9-pin
cross-cable.
established jama commands.
option key responds. Press
ENTER to activate this option
(see page 46).
.
sync signal is ON.
during playback and when
displaying menu screens
(sync signal is OFF).

Power On Start

Sets playback mode when power is turned on.
1
Press and hold HOME MENU for one
second.
The screen displays the ADV. SETUP menu.
2
Use the (cursor down) button to
select POWER ON START.
3
Use the (cursor left/right) buttons
to select a mode other than OFF,
then press ENTER.
• When OFF is selected, the Power On Start
function is disabled.
4
Use the (cursor up/down) buttons
to select 1, 2, or 3, then press ENTER.