Kenwood Nexedge Instruction Manual page 24

If a key has been programmed with Individual or
Individual + Status
persons.
1 Press the key programmed as Individual or
Individual + Status.
2 Press
• You can enter the unit ID directly, using the DMF keypad.
3 Press and hold the PTT switch to make the call.
• Speak into the transceiver as you would during a normal
transmission.
Select the desired zone and channel. If signaling has been
programmed on the selected channel, you will hear a call only
if the received signal matches your transceiver settings.
Note: Signaling allows your transceiver to code your calls. This will
prevent you from listening to unwanted calls. Refer to "S
on page 23 for details.
When you receive a group call on a Conventional channel
and the received group ID matches the ID set up on your
transceiver, you can hear the caller's voice.
When you receive a group call on a Trunking channel, the
transceiver automatically switches to the communications
channel to receive the call.
When you receive an individual call, a ringing tone will
sound and the caller's ID will appear on the display. To
respond to the call, press and hold the PTT switch and
speak into the transceiver as you would during a normal
transmission.
/ to select a unit ID from the list.
"
IGNALING
11