Category 4 Parameters: Transparent Bolier; Category 5 Parameters: Fault History - Honeywell CM737 User Instruction

CM737
User instruction
3.5

Category 4 parameters: Transparent Bolier

Parameter Para-
meter
N:o
P_heat 1
I_heat 2
Run time valve 3
3.6

Category 5 parameters: Fault History

Parameter Para-
meter
N:o
In this category the occurred boiler errors can be viewed, beginning with the most recent boiler error.
1)
Only if the setting is allowed by the heating appliance. Standard settings and limits can be set by the heating appliance.
2)
Only available if supported by the heating appliance.
3)
Only available if the outside temperature sensor is mounted.
4)
Category 4 & 5 parameters are only available if supported by the heating appliance. This will depend on the type of boiler
electronics in the heating appliance connected with the CM737.
Notes: Always remember to press the green
To exit the Installer Set-Up Mode press the AUTO or MAN button.
Factory Default Setting
Display Description
0 Proportional band
1 Integral factor
15 Time needed to open
or close valve
completely
Factory Default Setting
Display Description
button to confirm that you want to store the new Installer Set-Up setting.
14
Optional Setting
Display Description
1K
0.1 / minute
10 seconds
Optional Setting
Display Description