Cam-Acl-Egress - Dell S6100 Configuration Manual

Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.11(0.0)
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.4.(0.0)
9.2(1.0)
9.2(0.2)
9.1.(0.0)
8.3.19.0
8.3.11.1
8.3.10.2
8.3.10.0
8.3.1.0
8.2.1.0
7.8.1.0
Usage Information
Save the new CAM settings to the startup-config (write-mem or copy run start) then reload the system
for the new settings to take effect.
The total amount of space allowed is 12 FP Blocks. System flow requires three blocks; these blocks cannot be
reallocated. Only 9 number of blocks can be configured by the user .
If allocation values are not entered for the CAM regions, the value is 0.
If you enable BMP, to perform a reload on the chassis to upgrade any configuration changes that have changed
the NVRAM content, use the command reload conditional nvram-cfg-change.

cam-acl-egress

Allocate CAM for egress ACLs.
Syntax cam-acl-egress default | l2acl number ipv4acl number ipv6acl number
Description
Added the keyword ipv4udfmirracl.
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Added the nlbcluster ACL keyword. Introduced on the S6000-ON.
Added support for PBR and VRF.
Introduced on the Z9500.
Added support for fcoe.
Added support for OpenFlow.
Introduced on the S4820T.
Introduced on the Z9000.
Clarified block information for the S4810.
Introduced on the S4810.
Added the keywords ecfmacl, vman-qos, and vman-dual-qos.
Introduced on the S-Series.
Introduced on the C-Series.
Content Addressable Memory (CAM) 455