Ospfv3 Commands - Dell S6100 Configuration Manual

Hide thumbs Also See for S6100:
Table of Contents

Advertisement

Version
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.8.0

OSPFv3 Commands

Open shortest path first version 3 (OSPFv3) for IPv6 is supported on the platform.
The fundamental mechanisms of OSPF (flooding, DR election, area support, SPF calculations, and so on) remain unchanged. However,
OSPFv3 runs on a per-link basis instead of on a per-IP-subnet basis. Most changes were necessary to handle the increased address size of
IPv6.
The Dell Networking implementation of OSPFv3 is based on IETF RFC 2740.
area authentication
Configure an IPsec authentication policy for OSPFv3 packets in an OFSPFv3 area.
Syntax
area area-id authentication ipsec spi number {MD5 | SHA1} [key-encryption-type]
key
Parameters
area area-id
ipsec spi number
MD5 | SHA1
key-encryption-
type
key
1148
Open Shortest Path First (OSPFv2 and OSPFv3)
Description
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Area for which OSPFv3 traffic is to be authenticated. For area-id, you can enter a number.
The range is from 0 to 4294967295.
Security Policy index (SPI) value that identifies an IPsec security policy.
The range is from 256 to 4294967295.
Authentication type: Message Digest 5 (MD5) or Secure Hash Algorithm 1 (SHA-1).
(OPTIONAL) Specifies if the key is encrypted.
The values are 0 (key is not encrypted) or 7 (key is encrypted).
Text string used in authentication.

Advertisement

Table of Contents
loading

Table of Contents