Husqvarna 701 Enduro 2017 Owner's Manual page 94

12 SERVICE WORK ON THE CHASSIS
Main work
–
Loosen nut
–
Remove nuts
–
Adjust the chain tension by turning adjusting screws
Guideline
Chain tension
Turn the adjusting screws
and right chain adjusters

marks
Info
The upper part of the chain must be taut.
Chain wear is not always even. Repeat this measurement at different chain
positions.
–
Tighten nuts
–
Make sure that chain adjusters
–
Tighten nut
V00509-10
Guideline
Nut, rear wheel spindle
Finishing work
–
Remove the motorcycle from the lift stand. (
 .

on the left and right.

on the left and right so that the markings on the left

are in the same position relative to the reference
. The rear wheel is then correctly aligned.

.

are fitted correctly on adjusting screws

.

left and right.
5 mm (0.2 in)
M25x1.5 90 Nm (66.4 lbf ft)
p. 77)
92

.