Husqvarna 701 Enduro 2017 Owner's Manual page 130

14 WHEELS, TIRES
–
Clean and grease the thread of the wheel spindle and nut
Long-life grease (
–
Mount the rubber damper and rear sprocket carrier in the rear wheel.
–
Position the rear wheel.
The brake linings are correctly positioned.
–
Push the rear wheel forward as far as possible and lay the chain on the rear sprocket.
–
Mount wheel spindle
yet.
–
Make sure that chain adjusters
Guideline
In order for the rear wheel to be correctly aligned, the markings on the left and right
chain adjusters must be in the same position relative to the reference marks
Info
Mount left and right chain adjusters
–
Tighten nut
V00510-10
Guideline
Nut, rear wheel spindle
–
Position wheel speed sensor
–
Mount and tighten screw
Guideline
Screw, wheel speed sensor
–
Operate the foot brake lever repeatedly until the brake linings are in contact with the
brake disc and there is a pressure point.
p. 203)

and chain adjuster

are fitted correctly on adjusting screws

.

in the drill hole.

.

.
 
. Mount nut , but do not tighten it

in the same position.
M25x1.5 90 Nm (66.4 lbf ft)
M6 6 Nm (4.4 lbf ft)
128

.

.