NETGEAR FWG114P Reference Manual page 29

Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P
3. Connect to the Internet
Figure 3-6: Setup Wizard
You are now connected to the router. If you do not see the menu above, click the Setup
a.
Wizard link on the upper left of the main menu.
Click Next and follow the steps in the Setup Wizard for inputting the configuration
b.
parameters from your ISP to connect to the Internet.
Note: If you choose not to use the Setup Wizard, you can manually configure your
Internet connection settings by following the procedure
Internet Connection" on page
Unless your ISP automatically assigns your configuration automatically via DHCP, you
will need the configuration parameters from your ISP as you recorded them previously in
"Record Your Internet Connection Information" on page
When the router successfully detects an active Internet service, the router's Internet LED
c.
goes on. The Setup Wizard reports which connection type it discovered, and displays the
appropriate configuration menu. If the Setup Wizard finds no connection, you will be
prompted to check the physical connection between your router and the cable or DSL line.
The Setup Wizard will report the type of connection it finds. The options are:
d.
• Connections which require a login using protocols such as
PPPoE, DHCP, or Static IP broadband connections.
• Connections which use dynamic IP address assignment.
• Connections which use fixed IP address assignment.
The procedures for filling in the configuration menu for each type of connection follow
below.
Connecting the FWG114P to the Internet
3-11.
M-10177-01
"Manually Configuring Your
3-3.
3-7