Buffalo WMR-300 User Manual page 5

Chapter 1 Product Overview
2 blinks (Red) :
*2
3 blinks (Red) :
*2
4 blinks (Red) :
*2
5 blinks (Red) :
*3
9 blinks (Red) :
*2
Continuously blinking
*1 Never unplug the USB cable while the Power/Diag LED is blinking continuously.
*2 Turn off AirStation first, wait for a few seconds, then turn it back on.
*3 Because the network addresses of both the Internet port (WAN port) and the LAN port are the
same, it is not possible to establish communication. Change the LAN-side IP address of the
AirStation.
4
AOSS button
5
Reset button
6
Internet Port
7
Factory Default
Settings
Flash ROM error.
Wired Ethernet LAN error.
Wireless LAN error.
IP address setting error.
System error.
: Updating firmware, saving settings, or initializing settings.
*1
To initiate AOSS, hold down this button until the Power/Diag LED flashes
(about 1 second). Then, push or click the AOSS button on your wireless
client device to complete the connection. Both devices must be powered
on for this to work.
To reset all settings, hold down this button until the Power/Diag LED
turns red (about 3 seconds). The power must be on for this to work.
10 Mbps and 100 Mbps connections are supported.
Note: In bridge/AP mode (router off ), the Internet port becomes a
regular LAN port.
This sticker shows the AirStation's SSID, default encryption key, and WPS
PIN code.
- 4 -