Cisco TelePresence SX10 Quick Set Administrator's Manual page 59

Cisco TelePresence SX10 Quick Set

Introduction
Factory reset the video system
Factory reset using the reset button
We recommend that you back up the log files and configuration of
the video system before you continue with the factory reset.
1. Lift the rubber flap on the back of the unit to uncover the reset
button (pin hole).
2. Use the tip of a pen (or similar) to press and hold the recessed
reset button until the screen turns black (approximately 10
seconds). Then release the button.
3. Wait while the video system reverts to the default factory
settings. The video system restarts automatically when
finished. This may take a few minutes.
The video system confirms the factory reset by displaying a
notification on the main screen. The notification disappears
after approximately 10 seconds
D15330.02 SX10 Administrator Guide CE8.1, APRIL 2016.
Configuration Peripherals
(page 2 of 2)
Maintenance Maintenance
Reset button (pin hole)
The recessed button can
be quite difficult to use.
You should feel the button
go down when pushed.
www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
59
Administrator Guide
System settings Appendices
Lift the rubber flap
to uncover the reset
button (pin hole).