Spin Basket - GE GTUP270EMWW Technical Service Manual

Water Pressure Sensor
The water pressure sensor is located to the left of
the washer control board.
The sensor operates on low voltage DC that can
be read from the control board connector J10. The
voltage will increase from 1.2 VDC (empty) to 3.6
VDC (full) across terminals 1-2, tan to violet.
Terminals 2-3, violet to black, will read the inverse
voltage, the voltage will decrease on fi ll. This test
is performed at the control board with the harness
attached.
To remove the water pressure sensor:
1. Remove the service panel. (See
2. Remove the squeeze-type clamp and pressure
tube from the water pressure sensor.
3. Disconnect the wire harness.
4. Remove the 1/4-in. hex-head screw that
attaches the water pressure sensor bracket to
the frame.
Disconnect
5. Release the 2 tabs and remove the water
pressure sensor from the bracket.
Tab
Tab
Tab
Tab
.)
Service Panel
Water
Pressure
Sensor
3 2 1
Clamp
Tube
Water Pressure
Sensor Bracket

Spin Basket

To remove the spin basket:
1. Remove the cover assembly. (See
.)
Assembly
2. Remove the agitator. (See
Note: In the following step, dampening straps are
not present on some 24-in. models.
3. Disconnect 4 dampening straps from the tub
cover by removing four 5/16-in. hex-head
screws. (See
Tub Cover
4. Lift the tub and pull each front suspension rod
out of the slot in the tub.
Suspension Rod
Slot
– 49 –
Cover
.)
Agitator
.)
Suspension Rod
Slot
(Continued Next Page)