Dryer Timer And Start Switch - GE GTUP270EMWW Technical Service Manual

Dryer Timer and Start Switch

The dryer timer, start switch, and timer voltage-
dropping resistor (electric models only) are attached
to the dryer control bracket.
Note: The dryer timer motor has an approximate
resistance value of 2.4K Ω.
Dryer Start Switch
Voltage-
Dropping
Resistor
Dryer Timer
Electric Dryer Control Bracket
Dryer Start Switch
Dryer Timer
Gas Dryer Control Bracket
To replace the dryer timer:
1. Place the control panel in the service position.
(See
Control Panel
2. Remove the 2 Phillips-head screws from the
control bracket, then remove the bracket from
the front panel.
Control Bracket
3. Mark and disconnect the wiring from the dryer
timer.
4. Using a small fl at blade screwdriver, push in on
the lock tab while rotating the timer clockwise.
Lock Tab
– 24 –
.)
(Continued Next Page)