Lid Lock - GE GTUP270EMWW Technical Service Manual

Lid Lock

When the lid is closed, the lid lock engages the lid
actuator and prevents opening the lid during the
spin cycle and while the basket is spinning.
The lock will be released approximately 5 seconds
after the basket stops spinning.
Note: If there is a power outage the lid lock can take
3 minutes to release.
Lid Lock
(below
opening)
The lid lock is attached to the cover assembly with
2 Phillips-head screws. (See
lid must be open to access the screws. The cover
assembly must be raised approximately 4 inches to
remove the lid lock.
The lid lock is connected to the washer with a wire
harness.
Lid Actuator
.) The
Cover Assembly
Lid Lock
Disconnect
Lid Lock Overview
Any time the lid is in the down position, the lid
actuator presses down on lid lock mechanism.
When the washer goes into spin or rinse, a lock
routine will occur. The control sends 120 VAC to
control board J7 pins 2 to 6.
The control also sends 120 VAC to J7 pins 6 and 7.
An audible click will be heard, and the lid will now be
in the locked position and cannot be opened.
– 47 –
12 OHMS
900 OHMS
12 OHMS
900 OHMS
(Continued Next Page)