Cisco TelePresence SX80 Installation Manual page 4

Installation guide for Cisco TelePresence SX80
Connect a PC (optional)
Connect a PC to the codec, in order to share
7
content locally or with conference participants.
Cisco offers a PC presentation cable that
connects the codec's DVI-I input and Audio line
in port (Euroblock), to the PC's VGA and mini jack
connectors.
Alternatively, you can use a standard HDMI cable
(not provided).
78-100153-01A0 | FEBRUARY 2014 | © 2014 Cisco Systems, Inc. All rights reserved.
PC, max 2
(DVI-I/Euroblock or HDMI)
Start using the system
Power (100-240 VAC, 50/60 Hz)
Always use the provided power cable.
The codec inlet or the wall socket outlet
must be easily accessible after installation.
Connect to power, then switch on the system.
8
Wait while the codec starts up. Normally this takes a few
minutes. It may include automatic software upgrade and
restart of Touch 10 and camera(s).
Follow the instructions on screen to set the language etc.
If your system is not set up to be automatically provisioned,
you must configure the system before you can make your
first call. This is described in the Getting Started Guide,
which is available at http://www.cisco.com/go/sx-docs
Power
switch