Cisco TelePresence SX80 Installation Manual page 3

Installation guide for Cisco TelePresence SX80
Connect to LAN, microphones, loudspeakers, Touch 10, cameras and displays
Make sure all units are switched off when connecting or disconnecting cables.
LAN (RJ-45)
1
Always use the
1 st Ethernet port
for LAN.
4 × programmable
GPIO pins
(Euroblock,
2 × USB
SWITCH
PoE
injector
AP
Touch 10 control panel (RJ-45)
4
Insert the provided PoE injector
between Touch 10 and the codec's
2 or 3 Ethernet port .
nd rd 2
The audio line outputs may be configured to be used for loudspeakers.
1
2 The Ethernet connector is behind the lid at the rear of Touch 10. The Ethernet cable between
Touch 10 and the PoE injector must be PoE rated (provided). The Ethernet cable between the PoE
injector and the codec is not required to be PoE rated (not provided).
78-100153-01A0 | FEBRUARY 2014 | © 2014 Cisco Systems, Inc. All rights reserved.
Microphones, max 8 (Euroblock, 3.5 mm)
2
If your microphone cable has 3 pins,
use ,
mute pin ( ) unused.
3.5 mm)
10 Gb Ethernet
Power
(100-240 VAC, To camera control
50/60 Hz)
Cameras, max 3 (HDMI)
4
5
How to connect cameras are described
overleaf. Note that different cameras use
different ports for camera control.
and ground ( ) and leave the
2 × stereo audio line in,
e.g. from PC
(Euroblock, 3.5 mm)
Video input, Analog video input:
e.g. from PC Composite, Y;
(DVI-I) S-video, Y and C
(BNC)
4
There is no DC power output from the camera control port. Use an external power supply for the
3
camera.
4 The codec's 2 nd and 3
Cisco's SpeakerTrack 60 and Precision 60 cameras (see details for the cameras overleaf).
Connect a network switch to the codec's 2
to support your devices.
Loudspeakers, mono or stereo (Euroblock, 3.5 mm)
3
Use speakers with amplifiers. The speaker/amplifier
should have balanced input to avoid ground loop noise.
2 × stereo audio line out,
e.g. to recorder
1
(Euroblock, 3.5 mm)
Camera control
for the PrecisionHD
1080p 4xS2 camera
6
Displays, max 3
(2 HDMI, 1 DVI-I)
rd Ethernet ports should be used for the Touch 10 control panel, as well as for
nd or 3 rd Ethernet port, if you need more than two ports
Serial port Ground
(D-SUB 9) (Protective earth)
Power
3
(D-SUB 9)