Cisco Nexus 7000 Reference page 16

poweroff
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
poweroff
To power off a supervisor of a line card module in the Cisco NX-OS, use the poweroff command.
Syntax Description
module module-number Specifies an I/O module. The range is from 1 to 18.
xbar xbar-number
Defaults None
Command Modes Global configuration mode
Supported User Roles
network-admin
vdc-admin
Release
Command History
4.0(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to take a supervisor module out of service:
switch# configure terminal
switch(config)# poweroff module 5
Related Commands Command
out-of-service
reload module
Cisco Nexus 7000 Series NX-OS High Availability Command Reference, Release 5.x
HACR-6
poweroff {module module-number | xbar xbar-number}
Specifies a fabric module. The range is from 1 to 5.
Modification
This command was introduced.
Description
Shuts down a supervisor module in the Cisco NX-OS software.
Reloads a module in a device.
Cisco Nexus 7000 Series NX-OS High Availability Commands
OL-23374-01