Table of Contents
Advertisement
Press the DIMM down until it is secured by the spring clips. (See
Step 6
Figure 6
Step 7
When the DIMM is installed, check the two alignment holes and ensure that the spring retainer is visible.
If it is not, the DIMM is not seated properly. If the DIMM appears misaligned, carefully remove it and
reseat it in the socket. Push the DIMM firmly back into the socket until the retainer springs snap into
place.
Repeat
Step 8
Installing the MSFC2
The MSFC2 that shipped after November 2001 is physically smaller than the previous MSFC2.
Note
To install the MSFC2 on the supervisor engine, follow these steps:
Step 1
Align the MSFC2 with the standoffs on the supervisor engine. The MSFC2 shipped before
November 2001 will also align with the male standoff. (See
mounting holes on the MSFC2 are aligned with the remaining standoffs.
78-14357-02
Installing the DIMM
Step 3
through
Step 7
for the second (upper) DIMM.
Catalyst 6500 Series Supervisor Engine 1A DRAM Upgrade Installation Note
Installing the MSFC2
Figure
6.)
Figure
7.) Make sure that the remaining
9
Advertisement
Table of Contents
