Introduction - Siemens SCALANCE XB-200 Web Based Management

Introduction

Validity of this configuration manual
This Configuration Manual covers the following products:
● SCALANCE XB-200
Below, the products are also called IE switches.
There are two variants of each device with different article numbers. The two variants
differ only in their factory settings. All other properties are identical.
This Configuration Manual applies to the following software version:
● SCALANCE XB-200 firmware as of version 1.1
Factory settings
EtherNet/IP variants
● Industrial Ethernet protocol: EtherNet/IP
● Redundancy mechanism: RSTP
PROFINET variants
● Industrial Ethernet protocol: PROFINET
● Redundancy mechanism: Ring redundancy
Purpose of the Configuration Manual
This Configuration Manual is intended to provide you with the information you require to
install, commission and operate IE switches. It provides you with the information you require
to configure the IE switches.
Orientation in the documentation
Apart from the configuration manual you are currently reading, the products also have the
following documentation:
● Configuration manual "SCALANCE XB-200 Command Line Interface"
This document contains the CLI commands that are supported by the IE switches
SCALANCE XB-200.
● Operating Instructions "SCALANCE XB-200"
This document contains information on installing, connecting up and approvals for the
products.
SCALANCE XB-200 Web Based Management
Configuration Manual, 04/2015, C79000-G8976-C360-02
1
7