Specifications; Additional Safety Rules - Makita 3706 Instruction Manual

ENGLISH
1-1. Shoe
1-2. Thumb screw
2-1. Bit
2-2. Collet nut
2-3. Shaft lock
2-4. Adapter
2-5. Wrench
2-6. Loosen
2-7. Tighten
3-1. Adapter
3-2. Collet nut
3-3. Collet cone
8-1. Shoe
8-2. Loosen

SPECIFICATIONS

Collet chuck capacity
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for cutting gypsum, wood, plastic
and soft wall tiles.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For European countries only
Noise and Vibration
The typical A-weighted sound pressure level is 84 dB (A).
Uncertainty is 3 dB(A).
The noise level under working may exceed 85 dB (A).
Wear ear protection.
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
These values have been obtained according to
EN60745.
Explanation of general view
8-3. Tighten
8-4. Thumb screw
9-1. Shoe
9-2. Circular guide
9-3. Projections
10-1. Shoe
10-2. Circular guide
10-3. Thumb screw
11-1. Knob
11-2. Tighten
11-3. Loosen
12-1. Knob
13-1. Thumb screw
13-2. Vacuum cover
Model
-1
)
Overall length
Net weight
Safety class
2
.
ENE012-1
For Model 3706
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this
ENF002-1
product is in compliance with the following standards of
standardized documents;
EN60745, EN55014, EN61000 in accordance with
Council Directives, 89/336/EEC, 98/37/EC.
ENG003-2
000087
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
Responsible manufacturer:
Makita Corporation Anjo Aichi Japan

ADDITIONAL SAFETY RULES

1. Hold tool by insulated gripping surfaces when
performing an operation where the cutting tool
may contact hidden wiring or its own cord.
Contact with a "live" wire will make exposed metal
parts of the tool "live" and shock the operator.
2. Wear eye protection and dust mask.
3. Ventilate your work area adequately.
4
14-1. Circular guide
14-2. Projections
14-3. Vacuum cover
15-1. Circular guide
15-2. Thumb screw
15-3. Vacuum cover
15-4. Loosen
15-5. Tighten
16-1. Vacuum cover
16-2. Hose 28
16-3. Hose for vacuum cleaner
17-1. Vacuum cover
17-2. Hose 28
17-3. Dust collector
3706
3.18 mm, 6.35 mm
32,000
250 mm
1.1 kg
/II
Yasuhiko Kanzaki CE2006
Director
ENH101-6
ENB050-2