Replacing The System Compactflash - Cisco ASA 5505 Hardware Installation Manual

Removing and Replacing the CompactFlash

Replacing the System CompactFlash

To replace the system CompactFlash, perform the following steps:
Align the new system CompactFlash with the connector on the riser card.
Step 1
Step 2 Push the system CompactFlash inward until it is fully seated in the connector, see
Figure B-12 Replacing the System CompactFlash
1
Replace the adaptive security appliance cover. See the
Step 3
page B-3
Reinstall the network interface cables.
Step 4
Cisco ASA 5500 Series Hardware Installation Guide
B-12
1
System CompactFlash
for the procedure.
Appendix B Maintenance and Upgrade Procedures
"Replacing the Chassis Cover" section on
Figure B-12.
OL-10089-01