Replacing The Ac Power Supply - Cisco ASA 5505 Hardware Installation Manual

Appendix B Maintenance and Upgrade Procedures

Replacing the AC Power Supply

To replace the AC power supply, perform the following steps:
Insert the new power supply into place and slide it towards the back of the adaptive security appliance.
Step 1
Step 2 Lift the rear of the adaptive security appliance from the surface and reinstall both screws.
Step 3 Insert the power supply brace and press down until it fits into place, as shown in
Figure B-8
1
2
Step 4 Connect the power connector to the system board.
Step 5 Replace the adaptive security appliance cover. See
Step 6 Reinstall the network interface cables.
OL-10089-01
Replacing the Power Supply Brace and the AC Power Supply
1
3
Back panel Power supply brace
Power supply 4 Front panel
Removing and Replacing the Power Supply
4
3
2
"Replacing the Chassis Cover"
Cisco ASA 5500 Series Hardware Installation Guide
Figure B-8.
for more information.
B-7