Repair Hints - Sharp MX-C250F Technical Handy Manual

REPAIR HINTS

SPECIFICATION
Model
Is it possible setup Inbound Routing
using Email destination addresses?
MX-C250F
MX-C300W
Can the Ethernet speed of the
MXC250/300 series be fixed?
TROUBLE CODES
C1-10 trouble after recovering from
MX-C250F
MX-C300W
GENERAL / MISC
MX-C301W SIM24-6 - SIM24-15 are missing?
MX-C250F
Double sheet feeding from the SPF
MX-C300W
60
Symptom
Power Save mode
H3-00 trouble
L4-06
MX-C250/300 series only supports Network Folder
destinations when configuring Inbound Routing.
Upgrade the MFP Firmware to Special ROM version
02.05.E1.f0
After reboot, Log in using Admin Mode via the Web page.
Under Network Setup > General Configuration, set Auto-
Negotiation, Speed and Duplex Modes accordingly
Upgrade the MFP Firmware to v02.00.E1 (or higher).
This may be caused by static electricity discharged due to
poor earthing of the fusing separation plate.
Add fusing separation earth spring [MSPRT0655QSZZ ],
screw [XEBS730P12000] & washer [XWHS730-05080] to
the rear side of the fusing unit.
Check to see if the wire harness for the primary transfer
positioning sensors is routed correctly and is not
clamped/pinched between the high voltage TC holder and
the chassis.
NG Example
To avoid counters that can be cleared accidentally
(affecting End User Counter data/information), these
Simulations are now hidden as default.
The SPF separation pad has been upgraded to the same
type used on MX-C301W. Replace with PSHEZ0837QSZZ
SHARP
Advice