Mme Service Configuration; S1-Mme Interface Configuration - Cisco ASR 5000 Series Administration Manual

▀ MME Service Configuration

MME Service Configuration
MME services are configured within source contexts and allow the system to function as a MME in the LTE wireless
data network.
I
allows the system to process EPS bearer contexts. Commands that configure additional MME service
properties are provided in the MME Service Configuration Mode Commands chapter of Command Line
Interface Reference.
These instructions assume that you have already configured the system level configuration as described in System
Administration Guide.
To configure the system to work as MME service:
Step 1
Create an interface in source context for S1-MME interface by applying the example configuration in the S1-MME
Interface Configuration section.
Step 2
Create the MME service and bind the S1-MME interface to an IP address by applying the example configuration in the
Creating and Binding MME Service section.
Step 3 Associate the eNodeB and network parameters for the MME service by applying the example configuration in the
Configuring eNodeB with Network Id Parameters section.
Step 4
Associate the eGTP service for S11 interface and MME-HSS service for S6a interface with MME service by applying
the example configuration in the Associating eGTP Service and MME-HSS Service section.
Step 5
Configure a DNS service if not configured already to provide DNS query for S-GW and P-GW with MME service by
applying the example configuration in the Configuring DNS Client Service section.
Step 6
Configure the security and other session parameters in MME service by applying the example configuration in the
Configuring S-GW and P-GW with MME section.
Step 7
Configure the security and other session parameters in MME service by applying the example configuration in the
Configuring Session and Security Parameters for EPS bearer Contexts section.
Step 8
Verify your MME configuration by following the steps in the Verifying MME Configuration section.
Step 9 Save your configuration as described in the Verifying and Saving Your Configuration chapter.

S1-MME Interface Configuration

Use the following example to configured the S1-MME interfaces in source context:
configure
context <vpn_ctxt_name> -noconfirm
interface <intf_name>
▄ Cisco ASR 5000 Series Mobility Management Entity Administration Guide
64
:
MPORTANT
This section provides the minimum instruction set for configuring a MME service that
MME Service Configuration Procedures
OL-22987-01