Mme Service Configuration Procedures - Cisco ASR 5000 Series Administration Manual

Chapter 3

MME Service Configuration Procedures

This chapter is meant to be used in conjunction with the previous chapter that describes the information needed to
configure the system to support MME functionality for use in LTE networks.
It is recommended that you identify the options from the previous chapters that are required for your specific
deployment. You can then use the procedures in this chapter to configure those options.
This chapter describes following:
Information Required to Configure the System
MME Service Configuration
eGTP Service Configuration
MME-HSS Service Configuration
Event IDs for MME Service
I
MPORTANT
Information and instructions for configuring PSCs/PSC2s to be active can be found in the Configuring System Settings
chapter of the System Administration Guide.
C
AUTION
conflicting or blocked IP addresses and port numbers for binding or assigning. In association with some service steering
or access control features, like Access Control List configuration, use of inappropriate port number may result in
communication loss. Refer respective feature configuration document carefully before assigning any port number or IP
address for communication with internal or external network.
OL-22987-01
:
At least one Packet Services Card (PSC/PSC2) must be made active prior to service configuration.
:
While configuring any base-service or enhanced feature, it is highly recommended to take care of
Cisco ASR 5000 Series Mobility Management Entity Administration Guide ▄
59