Remove And The Front Bezel And Front Bezel Vent - Toshiba TDP-S3 Service Manual

Remove and replace the front bezel and front bezel vent
The front bezel (TDP-S3/T3: 505-0972-xx;TDP-MT5: 505-1193-xx) fastens to the front of the projector.
The front bezel vent (TDP-S3/T3: 505-0969-xx; TDP-MT5: 505-1195-xx), in turn, fastens to the front
bezel. The Toshiba nameplate (TDP-S3/T3, 505-1060-xx; TDP-MT5, 505-1197-xx) snaps to the front of
the front bezel vent.
To remove the bezel vent, do the following:
1 Remove the focus and zoom rings (see page 11).
2 Use a small bladed screwdriver to pry off the Toshiba nameplate. The nameplate covers the
screws on the front bezel vent.
3 Use a T-10 driver to remove the M3x14 Torx screw on the end of the vent opposite the projection
lens.
TDP-S3/TDP-T3/TDP-MT5 Service Manual 13