Power over Ethernet (PoE) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Example
The following example force the powered device to identify the PSE uplink as 60
watts.
switchxxxxxx(config)# interface gi1
switchxxxxxx(config-if)# powered device forced 60watts
45.12 show power inline
To display information about the inline power for all interfaces or for a specific
interface, use the show power inline privileged EXEC mode command.
Syntax
interface-id
show power inline [
Parameters
•
interface-id—Specifies an interface ID. The interface ID must be an Ethernet
port.
Default Configuration
Show information for all ports.
Command Mode
Privileged EXEC mode
Examples
Example 1—The following example displays information about the inline power for
all ports (port power based).
switchxxxxxx(config)#
Port limit mode: Enabled
Usage threshhold: 95%
Trap: Enabled
Legacy Mode: Disabled
1
]
show power inline
45
900