Hitachi IJ RX2 Technical Manual page 129

(
b) Press the Start/Continue key.
The ink in the printer is drained from the drainage tube.
● To abort the sequence, press the Abort key. Then, follow the on-screen instructions to return the
recovery tube to its original position and press the Start/Continue key .
You are then returned to the "Circulation control" screen.
● When you have aborted the sequence, perform the procedure from
* When aborting the operation, be sure to return the recovery tube to its original position.
(
c) When the predetermined period of time elapses, follow the operation guidance on the
screen and place the recovery block of the Main ink tank block to original position.
Circulation control
Process：Ink replacement
Operation guide
Connect a recovery tube to the main ink tank as before.
Press [Start/Continue].
*1 Clean the connection at the end of the recovery tube sufficiently with the makeup ink,
and then connect it as it originally was.
*2 To prevent the recovery tube from becoming crimped, be careful not to let it cross
another tube.
Refill the IJ printer with ink.
3
Circulation control
Process：Ink replacement
Operation guide
Put ink into the ink reservoir.
When ready press [Start/Continue].
(
a) Pull out the reservoir.
Ink reservoir
[Service ]
[Service ]
Pull out
1 again.
2015.07.07 12:45
Com=0
Ink Drainage
Ink rep.
Ink refill
2015.07.07 12:45
Com=0
Ink Drainage
Ink rep.
Ink refill
●Replacing the ink 6-6