Cisco Catalyst 4500 series Administration Manual page 1736

___________________________________________________________________________
To ensure that the maximum number of ports are tested, ensure that both supervisor engines are present
Note
on power-up.
Supervisor Engine 6-E and Supervisor Engine 6L-E
Switch# show diagnostic result module 6 detail
Current bootup diagnostic level: minimal
module 6:
Overall Diagnostic Result for module 6 : PASS
Diagnostic level at card bootup: minimal
Test results: (. = Pass, F = Fail, U = Untested)
___________________________________________________________________________
Power-On-Self-Test Results for STANDBY Supervisor
prod: WS-X45-SUP6-E part: 73-10597-04 serial: JAE1132SXQL
Power-on-self-test for Module 6: WS-X45-SUP6-E
CPU Subsystem Tests ...
seeprom: Pass
Traffic: L3 Looopback ...
Test Results: Pass
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
71-18
First test failure time -----> n/a
Last test failure time ------> n/a
Last test pass time ---------> Jul 21 2011 20:25:20
Total failure count ---------> 0
Consecutive failure count ---> 0
4) supervisor-rx-errors ------------> .
Error code ------------------> 0 (DIAG_SUCCESS)
Total run count -------------> 1
Last test testing type ------> Health Monitoring
Last test execution time ----> Jul 21 2011 20:25:20
First test failure time -----> n/a
Last test failure time ------> n/a
Last test pass time ---------> Jul 21 2011 20:25:20
Total failure count ---------> 0
Consecutive failure count ---> 0
SerialNo :
1) supervisor-bootup ---------------> .
Error code ------------------> 0 (DIAG_SUCCESS)
Total run count -------------> 1
Last test testing type ------> n/a
Last test execution time ----> Jul 21 2011 13:35:55
First test failure time -----> n/a
Last test failure time ------> n/a
Last test pass time ---------> Jul 21 2011 13:35:55
Total failure count ---------> 0
Consecutive failure count ---> 0
Chapter 71 Performing Diagnostics
OL_28731-01