Controlling Other Equipment Using The Supplied Remote Control; Unit - Pioneer KRP-500A Operating Instructions Manual

Using with other equipment
Slide Show Setup
Display Mode
Playback Order
Repeat Mode
Playback Mode
Interval (sec)
If you have selected "Auto" in step 8, press / to select
9
"Interval (sec.)", and then press / to select the desired
display duration for individual images.
• You can select from among 3 seconds, 5 seconds, 10 seconds,
20 seconds, 30 seconds, 60 seconds, and 90 seconds.
10 To start the Slide Show screen, press RETURN to display
the thumbnail screen and then press RED.
• To quit the Home Gallery function, press HOME MENU.
Starting the Slide Show screen
After setting up for Slide Show, you can start Slide Show to
sequentially change images.
1 To start the Slide Show screen, press RED when a
thumbnail screen is displayed.
• With "Auto" selected for "Playback Mode", images
automatically change at the specified intervals.
• With "Manual" selected for "Playback Mode", press P+/P– to
change images.
• While images are automatically changing, you can stop and
hold automatic image change for approximately 90 seconds by
pressing RED. To resume, press RED again.
2 When quitting the Slide Show screen, press RETURN to
restore the thumbnail screen or HOME MENU to quit the
Home Gallery function.
Note
• When paused during a slideshow is played, the screen
automatically changes to the next image in five minutes.
• If no operation is continued for five minutes, the Home Gallery
function automatically finishes except when the slideshow is
played with "Loop" selected for the "Repeat Mode".
Adjusting the picture quality
When a thumbnail screen is displayed, press YELLOW. The same
picture adjustment screen as the PC source is displayed. For the
subsequent procedure, see page 32.
Controlling other equipment using the
supplied remote control unit
Normal
Using the supplied remote control unit, you can control other
Name Order
equipment in connection: a set-top box (STB), DVD player, HDD/
DVD recorder (DVR), BD player or VCR.
Single time
Before using this function, you need to preset the supplied remote
Auto
control unit with the manufacture code of the equipment to be
controlled. When you then want to control the equipment, press
3
SELECT on the remote control unit to select an appropriate mode
depending on the equipment; the selection is switched among TV,
STB, DVD/DVR, and VCR. The corresponding mode indicators on
the remote control unit show the currently selected mode.
Presetting manufacture codes
1
DVD/DVR, or VCR mode depending on the equipment.
2
selected mode goes off, press and hold SELECT, and then
press 1 on the remote control unit.
3
AV
SELECTION
TOOLS
SOURCE
TV
STB DVR VCR
• When you control a BD player, select the DVD/DVR mode.
Press SELECT on the remote control unit to select the STB,
After confirming that the indicator of the previously
• The corresponding mode indicator flashes.
Press 0 to 9 to enter a three-digit manufacture code.
• See the manufacture code list to identify an appropriate code.
• The mode indicator lights up for approximately one second and
then goes off; presetting the manufacture code is completed.
1
4
7
CH
RETURN
TOOLS
SOURCE
TV
STB DVR VCR
Note
• If you perform no operation for approximately one minute while
a mode indicator is flashing, the code presetting procedure is
quitted.
• If you enter a code not listed in the table, a mode indicator
flashes quickly for approximately one second and then flashes
as before.
• To quit the code presetting procedure halfway while a mode
indicator is flashing, you may press SELECT on the remote
control unit.
• The factory default manufacture codes for the STB, DVD/DVR,
and VCR modes are "000", "100", and "500" respectively.
DVD HDD
SELECT
DVD
2 3
5 6
8 9
CH
0
ENTER
DVD HDD
SELECT
DVD
10
53
En